info@xmperfectstone.com +86-592-2916208
How To Clean An Outdoor Slate Table Top

How To Clean An Outdoor Slate Table Top

Jul 08, 2020

Since slate does not react as easily with chemicals as marble, it is recommended to clean it with a neutral cleaner. It is recommended to clean slate floors with an air conditioner or other non-toxic cleaning solution such as a cleaning spray. 


Crystal Clean will also help to reduce the amount of soap scum that has accumulated, as well as the accumulation of dirt on the surface of the slate slab. 


Electric cleaning of slate floors, especially textured slate, helps to ward off water stains, but it is not recommended to clean slate countertops. Avoiding waxy cleaners is also important when placing a heated appliance pan of wax over the slate as the wax melts and discolors the stone. 


If you need to clean a slate board or repair scratches, slate is relatively easy to polish but can be embedded with a cloth. Leave the cloth on for 10 to 15 minutes, it can also help to loosen hard areas of dirt and may require a deep scrubbing. 


When you have removed all dirt and grease, wash the slate board with clean water and a clean cloth and dry it as it is. You can use a proprietary sealer that restores a flawless look to the front of your slate, but avoid the use of abrasives. If slate has been cleared of dirt or soap, rinse it with soapy water for a basic cleaning to remove soap residues. 


However, if it is an unprocessed stone, the slate should be ground to a fine powder such as sand or sandpaper or sprinkled with water. 


The best method depends on the type of watermark you are dealing with, but you will find that it is much easier to remove watermarks from the slate. These markings are usually created by cleaning your slate board with water or detergent and not wiping it dry. 


A simple mixture of soap and warm water is the best way to clean most slates. Sometimes it is hard water that can be wiped away easily, but sometimes it is a little more difficult. 


To clean a slate floor, use a sponge or mop dipped in soapy water to gently wipe the floor. Do not leave a puddle of water on the tabletop, as this could leave a stain. As with any other surface on a countertop, use a towel with no course to wipe the slate. 


Professional refinishing is recommended to remove etching marks and restore the natural surface of the stone. If you choose sealed marble, use a quality product, and follow the manufacturer's instructions for use. 


Turn the cloth over frequently and dab off any excess fluid with a clean, dry white cloth and wash it regularly. If fat or stains have formed, rinse with cold water for a few minutes and dab away any excess fluids. 


One manufacturer,  recommends applying a light layer of liquid car wax after cleaning to improve the appearance of the surface. also recommends using a clean, pH-neutral cleaner with a high-quality detergent. Some manufacturers give you the opportunity to maintain the shine of the original surface by using a non-toxic, low-glycerine solution. 


If you prefer to use a shop-bought cleanly - stick to a solution that has been made specifically for natural stones. Some recommend using vinegar to clean and maintain the stone surface, but no vinegar solutions to seal marble, limestone, travertine or onyx surfaces, as the acid in the vinegar damages them.

 

Strong chemicals can remove seals from the floor and cause damage to the stone when the slate is exposed. Therefore, avoid seals with strong chemicals such as benzene, acetone, gasoline, or benzyl chloride. 


It is important to get rid of dust, dirt, and dirt before you start with the mop, as it can seriously damage the slate. 


Marble is a naturally soft stone, so extra care must be taken when cleaning, so wipe the dust off your marble slab regularly and clean it of stains as quickly as possible. Use natural stone cleaners as they can even clean dirt and dirt from dirty tiles outdoors without damaging the surface of the stone. 


Routine cleaning products such as sealants and waxes can accumulate on the surface, hiding rich colors and gloss and damaging the stone. 


Wipe the surface with a dust wiper to remove loose particles, and then use a cleaner designed for natural stones such as slate. Some types of slate can flake off, creating a color that masks dust on the surface. Start by restoring the color of the slate tile and removing dust, dirt and other impurities. 


Simply wipe the surface with soap that you would normally use in the kitchen and then clean it with a clean cloth such as soap and water. 


Ceramic is extremely durable and therefore a good choice for both outdoor and indoor use. Don't worry, using a limestone cleaning gel is not something you need to do every day to make your ceramic tabletop look fresh and clean. It is great to use an extra glossy finish every now and then, but it is not worth using it every time.